Promotions and Rebates

An Air Conditioner tune-up can help you lower your utility bills and cooling operating costs…and increase your family’s safety.

Tune-up, clean and service your A/C and you could save you up to 30% of your monthly energy costs! – Source: Angie’s List

*Important: Don’t confuse what is commonly advertised in Regina as ‘servicing/tune-up your AC’ with Marshal’s rigorous AC Tune-up, Clean and Service.

Depending on your system, your AC Tune-up, Clean & Service with Marshal can include:

• Check furnace and a-coil grade (critical for condensing equipment).
• Check and clean the underside of a-coil (if accessible).
• Check and clean condenser coil.
• Install 1 new standard filter and leave 1 new as a spare.*
• Inspection of ductwork to check for potential loss of conditioned air.
• Measure temperature drop across the furnace.
• Measure and note operating system pressures and temperatures to insure efficient performance.
• Check condensate drain (clean, grade, condition, properly trapped).
• Check thermostat installation and operation.
• Inspect furnace blower section.
• Check blower belt and blower motor performance.
• Confirm operation of all safety controls/limits.
• Inspect contactor and controls (low ambient, cycle timer, etc.).
• Check refrigerant levels.
• Lubricate moving parts. This eliminates friction which increases energy costs and wear on your AC unit.
• Test and calibrate your thermostat, if necessary.
• Check/tighten/clean all electrical connections for safety (confirm proper ratings, installation and connections).
• Check line set insulation.
• Check lines and fittings for signs of leaks or oil.
• Inspect and test capacitors and many more!

Should repairs be needed (and approved by you), any necessary parts and labour would be extra and billed and our regular rates. An additional charge will apply for a second furnace/A/C at the same location.

Schedule your air conditioner Tune-Up and Clean to be serviced by June 30, 2023…and pay only $159.99!

Act now and call 306-522-3000 or fill out the form below for more information!

*Notes: In most cases, the cleaning of the blower can be done on-site. If unusually dirty, with customer approval, we can take it off-site for additional cleaning for an extra charge. 

-Standard filter sizes are: 20X25X1, 20X20X1, 16X25X1, and 16X20X1

Marshal reserves the right to change or cancel this offer at any time without prior notice. Certain terms and conditions apply, see purchase agreement for details. Offer only available in Regina and surrounding area, and cannot be combined with any other furnace offer.